Teac HA-P90SD Mode D'emploi page 10

USB cable for computer
connection
(USB micro-B connector to
USB A connector)
10
L M N
USB cable included with
iPod/iPhone/iPad device
L
Computer connection port
Use the included USB cable for computer connection (USB micro-B
connector to USB A connector) to connect this unit to a computer.
M
Force shutdown switch
Turn the power/volume knob to the OFF position, and then insert a
fine pin such as the end of a paper clip into this hole.
The unit turns off.
N
iPod/iPhone/iPad device connection port
Use the USB cable included with the iPod/iPhone/iPad device to con-
nect it to this unit.
o Connecting anything other than an iPod/iPhone/iPad to this port
could cause the operation time of the battery to be significantly
reduced.
Note about input sources
This unit does not have an input selection switch. When this unit is turned on,
the first device connected to it becomes the input source.
If multiple devices are already connected to this unit when it is turned on, the
input source will be selected with the following priority: computer connection
port, iPod/iPhone/iPad device connection port, digital audio input/output and
analog audio input jack, microSD card slot.
To change the input source, turn the unit off once and connect the desired
device.