Climadiff CLIMA17 Notice D'utilisation page 34

SLEEP: press this button to set to SLEEP mode. The speed of upper and lower fans will be set to LOW
speed. In SLEEP mode, speed cannot be changed. Pressing this button again will switch the sleep mode
off again.
Timer setting:
1. Setting timer off
When the air conditioner is running, press this button, the timer LED lamp is on, and meanwhile 88 Nixie
tube will flicker, at the moment, press UP and DOWN to adjust time from 1h to 24h. Between 1~24h of timer,
UP/DOWN adjustment once changes 1h. When the set time expires, the air conditioner turns off
automatically.
To be noted: in sleep mode, you can only adjust timer from 1h to 12h.
2. Setting timer on
When the air conditioner is in standby state, press TIMER, the timer LED lamp is on, and meanwhile 88
Nixie tube will flicker, at the moment press UP/DOWN to adjust time from 1h to 24h. Between 1~24h of
timer, UP/DOWN adjustment once changes 1h. During setting of timer, the operating modes after start can
be selected, if COOL mode is selected, the set temperature can be adjusted simultaneously; after the set
time expires, the air conditioner starts automatically and runs in the selected operating mode.
To be noted: in sleep mode, you can only adjust timer from 1h to 12h.
3. Change of the set time
In the running process of timer, if you are intended to change the existing timer, you can press TIMER once,
at the moment 88 Nixie tube will flicker and display the remaining time, during flicker pressing UP/DOWN
can increase/decrease time on the basis of the original time. If you press TIMER again during flicker, the set
time will be cancelled, namely timer quits.
Cool mode:
 In on or timer on state press MODE to select COOL mode. At the moment the corresponding LED on
panel displays.
 Press UP/DOWN to set appropriate temperature in a range of 18~30°C (64-86°F). When UP or DOWN
is pressed once, temperature will go up or down by 1°C or 1°F every time.
 Press SPEED to select appropriate speed, and LOW and HIGH speeds can be circularly selected.
 After selecting COOL mode, press SLEEP on remote control to enter SLEEP mode, both upper and
lower fans are forcibly set at LOW speed. If SLEEP is to be cancelled, press SLEEP again on your
remote control.
Dry mode:
 In on or timer on state press MODE to select DEHUMIDIFY mode. At the moment the corresponding
indicator lamp is on.
 Temperature and speed are not adjustable.
34