Control Panel - Epson TM-T88III Manuel D'utilisation

English

Control Panel

FEED button
This button feeds paper.
POWER LED
The POWER LED is on when the printer is on.
ERROR LED
This indicates an error.
PAPER OUT LED
On indicates a paper near end or out. Flashing indicates standby.
Using the Power Switch Cover
WARNING:
If an accident occurs with the power switch cover
attached, unplug the power cord immediately.
Continued use may cause fire or shock.
The enclosed power switch cover ensures that
the power switch is not pressed accidentally. To
use this cover, install it as shown on the right.
Attaching and Removing the Connector Cover
These instructions apply if a connector cover is packed with your
printer to protect your cables. To attach it, follow the steps below:
1. First, connect all the cables. The connector
cover has three possible cable exits: on the
right, left, and back. Remove the tab for the
exit you want to use by breaking it off with
your fingers. See the illustration on the right.
Note:
Once you remove a tab, you cannot replace it.
2. After removing the tab, also remove any protruding plastic, so
that the edge is smooth and does not damage the cables.
3. Position the two hooks on the connector cover so that they
hook the printer case, as shown on the left below.
4. Push the connector cover down to click onto the printer case.
4 TM-T88III User's Manual