EUROCOM X7200 Panther 2.0 Guide Utilisateur page 19

Concise User's Guide
SLI Multi GPU Configuration
This computer features an NVIDIA Scalable Link In-
terface (SLI) that improves graphic quality and perfor-
mance by combining dual NVIDIA GPUs (two video
cards are required) in a single system. To enable/disable
SLI Configuration:
1. Go to NVIDIA Control Panel (see
page 13).
2. Click "+" next to 3D Settings if its sub-items are not shown
and then click Set SLI Configuration.
Figure 9 - Set SLI Configuration
14 - Video Features
Video Features on
3. Click "Enable SLI technology (recommended)".
4. Click to "Select the display to view the SLI rendered
content on." (only a single display may be used).
5. Click Apply and Yes to restart the computer.
Note: DO NOT use the Fn + F7 key combination to tog-
gle through display options when SLI is enabled. SLI
supports only a Single display, and attempting to config-
ure dual displays may cause an error. Use the NVIDIA
Control Panel to select the display to be used.
SLI Multi GPU Configuration & Battery
Power
Note that due to the high power and system demands cre-
ated by enabling SLI Configuration, you should not en-
able SLI configuration if your computer is powered
by battery only. If you attempt to run an SLI configura-
tion when the computer is powered by the battery only,
then system problems may occur.
• If the computer is currently powered by battery only do not
enable SLI configuration.
• If you have currently enabled SLI configuration, and the
computer is powered by the AC/DC adapter, do not switch
to battery power only (or go to the NVIDIA Control
Panel and disable SLI configuration before switching to
battery power only).