Noise Development; Technical Data; Cleaning And Storage; Guarantee - Clatronic BS 1259 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
CAUTION:
You should always carry out this cleaning process if the
suction power of the device is reduced!
NOTE:
Simply allow the fi lters to dry in the air!
The device should only be used again when the fi lters are
dry!
Outlet fi lter (13)
The appliance is also equipped with an outlet fi lter.
In order to ensure that the fi lter works correctly, we recom-
mend that you replace it every six months.
It is located on the rear part of your appliance behind a
ventilation grid.
Open the ventilation grille by pressing the lever on its side.
Then pull the grille out towards the front. Remove the fi lter
and clean as described above. Fit the fi lter back into place
and close the ventilation grid by following the steps above in
the opposite order.

Cleaning and storage

Cleaning
Pull the plug out of the socket before cleaning!
Clean the casing with a dry cloth.
Storage
Let the iron cool down completely.
Wind the cable completely.
Insert the hook of the nozzle on the back of the device into
the parking aid (8).
Troubleshooting
The Device Does Not Work.
Remedy:
Check the connection to the mains.
Check the position of the switch.
The device does not suck up anything.
Possible Cause:
The suction power is set too low.
Remedy:
Check the position of the control switch.
Possible Cause:
The dust container or the fi lters are dirty.
Remedy:
Empty or clean the components.
Possible Cause:
There is a foreign body in the suction tube or the nozzle.
Remedy:
Check the accessories for foreign bodies.
05-BS 1259 33
NOTE:
Cleaning may become necessary after a shorter time,
depending on the conditions of use, e.g. when vacuuming
fi ne dust.
If the suction power of your vacuum cleaner diminishes
please clean the fi lters as described.
If the suction power suddenly diminishes during operation
this may be due to the fi lters being locked.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 76,0 dB(A) (no limit)

Technical Data

Model:...............................................................................BS 1259
Power supply:............................................................230 V, 50 Hz
Power consumption:
P
:............................................................................ 1200 W
nom.
P
:............................................................................ 1800 W
max.
Protection class:.......................................................................... ΙΙ
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month
guarantee starting on the date of purchase (receipt).
During the life of the guarantee any fault of the device or its
accessories ascribable to material or manufacturing defects will
be eliminated free of charge by repairing or, at our discretion, by
replacing it. The guarantee services do not entail an extension
of the life of the guarantee nor do they give rise to any right to a
new guarantee!
Proof of the guarantee is provided by the proof of purchase.
Without proof of purchase no free replacement or repair will be
carried out.
If you wish to make a claim under the guarantee please return
the entire machine in the original packaging to your dealer
together with the receipt.
Defects to consumables or parts subject to wearing as well as
cleaning, maintenance or the replacement of said parts are not
covered by the guarantee and hence are to be paid!
The guarantee lapses in case of unauthorized tampering.
33
19.09.2006, 9:18:32 Uhr

Publicité

Table des Matières
loading

Table des Matières