Clatronic BS 1259 Mode D'emploi page 32

Winding
Press the cable winding button and guide the cable. Hold the
cable to avoid wrapping.
Telescope Vacuum Pipe
Nozzle accessories
Groove and brush nozzle:
Upholstery nozzle:
Floor nozzle:
Releasing the nozzles:
Air Slide
Open the air slide on the hose handle in order to regulate the
airfl ow or to clear any particles sticking to the nozzle.
32
05-BS 1259 32
• The height-adjustable vacu-
um pipe enables individual
alignment to your height.
• Unlock the coupling by pres-
sing the key in the direction
of the arrow
• Slide the vacuum pipe to the
desired length.
• To lock the device, release
the key until you hear it lock
in place.
For vacuuming upholstery, cur-
tains and in corners and crevices
etc.
„2-in-1" nozzle: When this is
folded together it can be used as
a groove nozzle. If you would like
to use the brush nozzle, pull the
brush section in the direction of
the arrow until it locks in place.
For cleaning upholstery, curtains
etc.
To clean carpets or smooth
surfaces.
In order to facilitate control, the
fl oor nozzle is fi tted with rollers
and can be adjusted to suit the
circumstances.
Carpet: make sure that the
brushes on the fl oor nozzle
are deactivated when cleaning
carpets. If this is not the case,
press the lever on the fl oor nozzle
forwards with your foot.
In order to vacuum even
surfaces, for example, press the
lever back with your foot. This
activates the brushes (you can
tell whether this is the case by
checking that the brushes are
visible on the fl oor nozzle).
Pull these off while turning
slightly.
Filter
• Your machine has three fi lter systems. The traditional dust
bag system has been replaced by a dust container. In this,
coarse dirt particles and tiny particles fl oating in the air are
swirled out of the suction air by the high speed of the air
current.
• The purchase of dust bags is no longer necessary.
Removing the Dust Container and Filter
If the fi lling level indicator (1) changes from green to red the dust
container needs to be emptied. Please proceed as follows:
•
•
Illustration A
Illustration B
• Turn the insert (c) slightly in an anticlockwise direction in
order to release it from the dust container (6).
• Pull the lamella fi lter (b) out of the insert (c).
• The lamella fi lter is wrapped in a fi lter net (a), which you can
remove by means of a Velcro® fastener.
• The fi lter fl eece (d) is only attached on the top.
Cleaning the Dust Container and Filter Inserts
• Always empty the dust container fi rst.
• After use you can rinse out the dust container with clean
water.
• Any soiling in the container can be removed with a sponge
or nylon brush.
Lamella Filter, Filter Net, Filter Fleece
• Quick clean: Tap or brush the fi lters out in order to remove
any residues. The quick clean is recommended every time
the dust container is emptied.
• Hand wash: In the case of more intense soiling we recom-
mend a hand wash up to 40°C.
Release the suction hose
from the connection.
Press the button (5) and pull
the dust container upwards to
lift it out (see illustration A).
19.09.2006, 9:18:30 Uhr