Yamaha MusicCast SUB 100 Mode D'emploi page 21

Network
Problem
Network functionality cannot be
used.
Can't connect to the wireless LAN
router (access point).
Can't connect to the internet via
the wireless LAN router (access
point).
This unit is not detected by the
MusicCast CONTROLLER app.
The wireless network cannot be
found.
Can't make connection settings
using the MusicCast
CONTROLLER app.
Failed to update the firmware via
the network.
Can't connect with the Pairing
Master.
Cause
Network information (IP address) has not been
obtained correctly.
MAC address filtering is enabled on the
wireless LAN router (access point).
The wireless LAN router (access point) is
powered-off.
The wireless LAN router (access point) and
this unit are too far apart.
There is an obstacle between the wireless LAN
router (access point) and this unit.
This unit and the mobile device are not
connected to the same network.
A device that generates electromagnetic
radiation (such as a microwave oven or radio
equipment) is located nearby.
Access to the network is being restricted by the
firewall settings of the wireless LAN router
(access point).
The mobile device is not connected to the
wireless LAN router (access point).
You're using a router that has multi-SSID
support.
The state of the network connection is not
good.
The Pairing Master is not a MusicCast
Surround/Stereo compatible device.
The connection is not correct. Alternatively,
the connection is faulty.
Pairing with another device has already been
registered.
TROUBLESHOOTING
What to Do
Enable the DHCP server function of your
router.
Connection is not possible if MAC address
filtering is enabled. Change the settings of the
wireless LAN router (access point) so that
connection can occur.
Power-on the wireless LAN router (access
point).
Locate the wireless LAN router (access point)
and this unit closer together.
Locate the wireless LAN router (access point)
and this unit where there is no obstacle
between them.
Check the network connections and the router
settings, and connect them to the same
network.
If using this unit with a wireless connection, do
not use it near a device that generates
electromagnetic radiation.
Check the firewall settings of the wireless LAN
router (access point).
Connect the mobile device to the wireless LAN
router, and then use the MusicCast
CONTROLLER app to make settings.
The router's network separation function might
be making it impossible to access this unit.
When connecting a mobile device, use an SSID
that allows access to this unit (try connecting to
the primary SSID).
Wait a while, and then try updating again.
Use a MusicCast Surround/Stereo compatible
device, or a device that allows analog
connections.
After initializing this unit, check that the
Pairing Master is a MusicCast Surround/Stereo
compatible unit, and then connect again.
Cancel the registered pairing with that device,
and make the registration settings again.
English
21
En