Safety Information; Safety Warnings; Ground Connection Warnings; Power Cords, Plugs And Charging Cable Warnings - VESTEL EVC02-AC22 Série Manuel D'utilisation

Masquer les pouces Voir aussi pour EVC02-AC22 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INFORMATION

CAUTION
RISK OF ELECTRIC SHOCK
CAUTION :
VESTEL EV CHARGER MUST BE INSTALLED ONLY
BY A LICENSED AND EXPERIENCED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE LOCAL AND
NATIONAL ELECTRICAL CODES AND STANDARDS.
IMPORTANT - Please read these
instructions fully before installing or
operating

SAFETY WARNINGS

Keep this manual in a safe place. These safety
and operating instructions must be kept in a
safe place for future reference.
Check that the voltage marked on the rating
label and do not use charging station without
appropriate mains voltage.
Do not continue to operate the unit if you are
in any doubt about it working normally, or if it is
damaged in any way - switch off, withdraw the
mains plug and remove the energy. Consult
your local dealer.
The ambient temperature range during
charging should be between –30 °C and +50
°C and at a relative humidity of between 5 %
and 95 %. Use the charging station only within
these specified operating parameters.
The charging station is intended for outdoor
and indoor use but which may also be used in
public places.
To reduce the risk of fire, electric shock or
product damage, do not expose this unit to
severe rain, snow, electrical storm or other
severe weathers. Moreover, the charging
station shall not be exposed to spilled or
splashed liquids.
Do not touch end terminals, electric vehicle
connector and other hazardous live parts
of the charging station with sharp metallic
objects.
Avoid exposure to heat sources and place the
unit well away from near flammable, explosive,
harsh, or combustible materials, chemicals, or
vapors.
Risk of Explosion. This equipment has internal
arcing or sparking parts which should not be
exposed to flammable vapors. It should not be
located in a recessed area or below floor level.
This device is intended only for charging
vehicles not requiring ventilation during
charging.
To prevent risk of explosion and electric shock,
ensure that the specified Circuit Breaker and
RCD are connected to building grid.
The lowest part of the socket-outlet shall be
located at a height between 0,4 m and 1,5 m
above ground level.
WARNING: Never let people (including
children) with reduced physical, sensory or
mental capabilities or lack of experience
and or knowledge use electrical devices
unsupervised.

GROUND CONNECTION WARNINGS

The Electric Vehicle Charger (EVC) must be
connected to a centrally grounded system.
The ground conductor entering the EVC must
be connected to the equipment grounding
lug inside the charger. This should be run
with circuit conductors and connected to the
equipment grounding bar or lead on the EVC.
Connections to the EVC are the responsibility
of the installer and purchaser.
To reduce the risk of electrical shock, connect
only to properly grounded outlets.
POWER CORDS, PLUGS and
CHARGING CABLE WARNINGS
Be sure that vehicle charge cable is Type 2
socket compatible on charging station side.
A damaged power cord/plug or EV cable can
cause fire or give you an electric shock. Do not
use this product if the flexible power cord or
EV cable is frayed, has broken insulation, or
shows any other signs of damage.
Ensure that the charge cable is well positioned
thus; it will not be stepped on, tripped over, or
subjected to damage or stress.
Do not forcefully pull the charge cable or
damage it with sharp objects.
Never touch the power cord/plug or EV cable
with wet hands as this could cause a short
circuit or electric shock.
To avoid a risk of fire or electric shock, do not
use this device with an extension cord. If the
mains cable or EV cable is damaged it must
be replaced by the manufacturer, its service
agent, or similarly qualified persons in order to
avoid a hazard.
English - 2 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Evc02-ac11 sérieEvc02-ac22grw-wmEvc02-ac11grw-w

Table des Matières