Luda Elektronik tractorCam Guide D'utilisation page 50

• Incorrect channel chosen.
• The camera is supplied with power
(the power indicator is lit up) but you
still receive no signal.
• The camera is not supplied with power
(the power indicator isn't lit up)
• The signal is not good enough.
• The camera isn't paired with the
monitor. (The pair indicator isn't lit up)
• The camera isn't set to ON in the
monitor.
Bad reception/low frame rate
Possible error
• The picture updates slowly due to bad
reception.
Black & white picture
Possible error
• Pale colours or black & white picture.
on the back of the camera and that it is
tightly fastened.
• Choose the channel the camera is
transmitting on.
• Make sure that the antenna is thoroughly
attached to the back of the camera, pair
the camera and monitor.
• Start the tractor and turn on the power
to the power source.
• Make sure that the joints are carefully
put together. Further make sure that the
power cable is not broken or pinched.
• Draw power from somewhere else or
purchase our battery pack accessory.
• Change antenna or move the camera/
antenna to another position where the
signal reaches the monitor better.
• Pair the camera with the monitor as
described in chapter 9.
• In the monitor menu, set the camera
to ON. (Or reverse if you would like a
mirrored image.) See chapter 3.
Action
• Switch to QVGA mode. (See chapter 5.)
• Change antenna or move the camera/
antenna to another position where the
signal reaches the monitor better.
Action
• In dark conditions the IR-LEDs will
automatically switch on resulting in pale
colours. In pitch-black surroundings the
picture will become black & white.
- 50 -