Settings; Tool Holder, Attachments - Festool CXS Guide D'utilisation

Consider the pictures on the fold-out page.
Changing the direction of rotation
The right/left switch [1-5] changes the direction of
rotation.
• Move switch from right to left = clockwise rota-
tion
• Move switch from left to right = anticlockwise ro-
tation
Changing gear
Always switch off the machine before changing
gear!
You can change gear using the gear switch [1-4].
• Switch forwards (Number 1 visible) = first gear
• Switch backwards (Number 2 visible) = second
gear
WARNING
Risk of injury
Make sure that the machine is switched off and
the battery pack has been removed before
changing the tool holding fixure, attachments
and tools.
Tool chuck CENTROTEC WH-CE
The tool chuck CENTROTEC WH-CE allows you to
change tools with a CENTROTEC shank in a matter
of seconds.
Always use a CENTROTEC tool chuck to clamp
CENTROTEC tools..
CAUTION
Tool has sharp edges and can cause cutting inju-
ries curing a tool change!
Wear protectiv gloves!
Changing tools
Pull back the green release ring [6-2] to attach

Settings

By turning the torque thumbwheel [1-1] the re-
quired torque can be adjusted. The arrow [1-3]
aligns with the adjusted state.
Drilling
Turn the torque thumbwheel [1-1] so that its
marking [1-3] faces the drilling symbol [1-2]. Max-
imum torque is set in this position.
Fastening
Adjust the torque accordingly at the torque thumb-
wheel [1-1]:
Position 1 = low torque
Position 12 = high torque
The machine switches off when the present torque
is reached. The machine only continues running
when the on/off switch [1-6] is released and
pressed again.

Tool holder, attachments

WH-CE
CENTROTEC
6
Attaching the CENTROTEC
Pull the release ring [6-3] forwards.
Attach the tool chuck to the drill spindle [6-4].
Release the ring [6-3].
Detaching the CENTROTEC
Pull the release ring [6-3] forwards.
Remove the tool chuck.
or detach tools with a CENTROTEC shank.
Adjusting torque
®
6-2 6-3 6-4
6-1
11