Functional Description - Makita UB001C Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the machine
is switched off and the portable power pack is
disconnected from the machine before adjusting
or checking function on the machine.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery life.
The machine will automatically stop during operation if
the machine or battery is placed under one of the fol-
lowing conditions:
Overload protection
When the machine or battery is operated in a manner that
causes it to draw an abnormally high current, the machine
automatically stops and the main power lamp of the
machine blinks in green. In this situation, turn the machine
off and stop the application that caused the machine to
become overloaded. Then turn the machine on to restart.
Overheat protection
When the machine or battery is overheated, the machine
stops automatically. When the machine is overheated,
the main power lamp of the machine lights up in red.
When the battery is overheated, the main power lamp of
the machine blinks in red. Let the machine and battery
cool down before turning the machine on again.
Overdischarge protection
When the battery capacity is not enough, the machine
stops automatically and the main power lamp of the
machine blinks in red. In this case, remove the battery
from the machine and charge the battery or change the
battery to fully charged one.
Main power switch
WARNING:
Always turn off the main power
switch when not in use.
To turn on the machine, press the main power switch.
The main power lamp lights up in green. To turn off,
press the main power switch again.
1
2
► 1. Main power lamp 2. Main power switch
NOTE: This machine employs the auto power-off
function. To avoid unintentional start up, the main
power switch will automatically shut down when the
switch trigger is not pulled for a certain period after
the main power switch is turned on.
NOTE: If you press the main power switch when the
control lever is not fully returned to the off position,
or while you are pulling the switch trigger, the main
power lamp blinks in green. In this case, fully return
the control lever, or release the switch trigger, and
then press the main power switch.
Switch action
WARNING:
Before connecting the portable
power pack to the machine, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the machine, simply pull the switch trigger. The
speed increases by increasing pressure on the switch
trigger. Release the switch trigger to stop.
► 1. Switch trigger
8 ENGLISH
1