Safety Instructions; Mounting The Antenna - Carrera RC 301001 Instructions De Montage Et D'utilisation

Safety instructions

1
2
ON
1 2
ON
3
4
5
6
7
A Carrera RC boat is a remote-
controlled model boat that uses special
rechargeable batteries for this purpose.
Only original Carrera RC Li-Ion
rechargeable batteries may be used.
When starting, always switch the
controller on first, then the boat.
When finishing, always reverse the
order of these actions!
Do not run your boat during a thunder-
storm! Atmospheric interference can
lead to malfunctions.
Do not expose the Carrera RC boat to
direct sunlight.
To avoid the electronics in the car over-
heating, when temperatures are above
35 °C regular short pauses in operation
are essential.
Handle the tip of the antenna with care.
Danger of injury!
Never use strong solvents for cleaning
your model.
Please clean the water sensor contacts
regularly with tap water and a little vine-
gar-based cleaner.
8
9
RED = Charging GREEN = Ready
10
11
12

Mounting the antenna

1
9 9
After each running session, open the
two drainage plugs at the bow and stern
and pour away any condensation which
may have accumulated.
Only replace the plugs in these open-
ings immediately before you use the
boat for another running session.
To avoid malfunctions to the control
system resulting in uncontrolled opera-
tion of the Carrera RC boat, check that
the controller batteries and the
rechargeable batteries in the boat
have sufficient charge.
The Carrera RC boat must be inspected
before and after operation, each time it
is used, to ensure that it has not become
disassembled. Any screws or nuts that
may have become loosened during
operation must be tightened.
Safety propeller
The propeller switches off on being
taken out of the water.
Please note particularly that the propel-
lers have no function out of the water.
The boat cannot be operated on the
ground.
The toy is to be operated in water only
when fully assembled.
Please ensure your remote control batte-
ries have the required capacity and
make sure the LI-Ion power pack is fully
charged.
Feed the antenna cable through the
antenna tube and then fix this to the
Carrera RC-model. Secure the end of
the antenna cable with a Carrera RC
sticker from the logo sheet.