BH FITNESS G2350 Instructions De Montage Et Utilisation page 20

Now use the screws (110) (16) to
attach them to the post.
G2350
EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(127), located on the main post (21),
offering various exertion settings.
To increase pedal resistance turn the
tensioning control (127) clockwise (+)
until the exertion level best suits your
exercise requirements.
To reduce pedal resistance turn the
tensioning control (127) anticlockwise (-).
G2351
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(116) into the connection hole (k) on
the main body (101) (bottom, rear of
the machine) and then plug the
transformer into a 220 V mains supply,
Fig.17.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (69) up or down, as
shown in Fig.15.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (104)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.16. Store your unit in a dry place,
preferably not subject to changes in
temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
20