Publicité
Les langues disponibles
Les langues disponibles
9. FITTING THE UPPER
FOCUS BARS.-
G2351. Take hold of the Hand-grip
connectors (2), sticking out of the top
bars (7L) and (7R).
Take the top left bar (7L) (marked with
the letter "L").
Insert the top bar onto the bottom left
focus bar (15L), lining up the letters
(L), Fig.11, fit the screws (9), the
washers
(10)
securely. Now go through the same
procedure for the top right focus bar
(7R).
10. FITTING THE FOOTRESTS.-
Next, remove the screws (48), the flat
washers (89) (91) and the knobs (90)
and position the right footrest (47R)
(marked with the letter "R") on top of
the unit's right foot (45), Fig.12, (left
and right refers to the user's position
doing exercise) refit the knobs (90),
the washers (89) (91) and the screws
(48) removed previously and tighten
securely.
Next, position the left footrest (47L)
(marked with the letter "L") on top of
the left foot (45), refit the knobs (90),
the washers (89) (91) and the screws
(48) removed previously and tighten
securely.
11. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE
G2350. Take hold of the cable (126),
which is sticking up out of the main
post (21), and plug it into the
connector of the electronic unit (1), as
shown in Fig.13.
G2351. Take hold of the cable (19),
which is sticking up out of the main
post (21), and plug it into the
(13)
and
tighten
connector of the electronic unit (1), as
shown in Fig.13.
FITTING THE HAND-GRIP CABLE.
G2351. Take hold of the Hand-grip
connectors (2), sticking out of the
main post (21), and plug them into the
connectors located at the back of the
monitor (1), as shown in Fig.13.
ATTACHING THE MONITOR.-
Release screws (20), Fig.13, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(21) in the direction of the arrow,
Fig.14, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(20) removed previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
12. FITTING THE HANDLEBAR.-
Take the handlebar (112), remove
screws (14), position the ends of the
handlebar on the plate at the top of
the main post (21), Fig.14. Refit the
screws (14) removed previously.
FITTING THE HAND-GRIP CABLE.
G2350. Take hold of the Hand-grip
connectors (128), sticking out of the
main post (21), and plug them into the
connectors located at the back of the
monitor (1), as shown in Fig.13.
G2351. Take the covers (18B) (18F)
(8R) (8L) and position them on the
main post (80), Fig.14.
19
Publicité
