Beko DRYPOINT M PLUS Instructions De Montage Et De Service page 3

4. Absperreinheiten
Absperrelemente nicht schlagartig öffnen.
Eine Bypassleitung um die Einheit wird empfohlen.
5. Montage/Inbetriebnahme
Vor Einbau des Membrantrockners Leitungen gründlich
reinigen (z.B. durch Ausblasen).
Einbaurichtung von Filtern und Membrantrockner be-
achten (vgl. Kennzeichnung der Durchflussrichtung auf
den Köpfen).
6. Befestigung DRYPOINT M PLUS
Im Lieferumfang des Membrantrockners sind Wandhal-
ter enthalten. Die Befestigung so anbringen, dass beim
Wechsel der Filterelemente keine Beschädigungen am
Membrantrockner auftreten können.
7. Dichtmittel
Achtung: Alle Gewinde vor und am DRYPOINT M-
Druckluft-Membrantrockner mit Teflonband eindichten.
Keine flüssigen Dichtmittel benutzen.
english
. Liability for defects
Please read this information very carefully:
Liability for defects can only be accepted if the following
rules and the instructions for installation are complied
with.
Provided appropriate CLEARPOINT filters are being
used and the filter elements are replaced once a year,
the purchaser of the compressed-air membrane dryer
shall be entitled to claim remedy of defects within 2 years
from date of invoice.
BEKO shall not be liable for damage due to improper
or incorrect use, wear, storage or other actions by the
purchaser or third parties.
This applies in particular to wearing parts.
. Temperature
There must be no danger of frost at the place of installa-
tion; the temperatures at the place of installation and of
the compressed air should be between +2 and + 60 °C.
DRYPOINT DM 10-41 C-N, 10-47 C-N, 20-48 C-N, 20-53 C-N, 20-60 C-N, 20-67 C-N
Wichtige Hinweise • Important Notes
3. Filters
Please observe the relevant filter requirements (see
page 8 - 9):
Dirt particles, oil residues and liquid condensate have
to be safely retained.
For these purposes a CLEARPOINT nanofilter N (0,01µ)
is integrated in the membrane dryer housing. With high
dirt loads or large amounts of condensate, it will be nec-
essary to install a CLEARPOINT F fine filter (1 µm) in
addition and, where appropriate, a W water separator.
Note: The filter elements need to be replaced once a
year.
This applies for the replacement of the nanofilter as
well which is an integrated part of the membrane
dryer:
- Remove bottom part of the membrane dryer housing
(fine thread). In doing so hold the upper part tight in
its position.
- check the float drain and replace it, if required
(FAD055)
- Exchange the filterelement and reassemble the two
body parts and screw tight
4. Shutoff units
The shutoff elements must not be opened suddenly. It is
recommended to install a bypass around the unit.
5. Installation/putting into service
Clean the pipes thoroughly (e.g., by blowing through
them) before installing the membrane dryer.
Observe the installation direction of filters and membrane
dryer (see marking indicating the direction of flow on
the heads).
6. Mounting of DRYPOINT M PLUS
The membrane dryer is supplied together with wall
brackets. Ensure that replacement of the filter elements
cannot damage the membrane dryer.
7. Sealing material
Note: Use Teflon tape to seal off all threaded connections
upstream of the DRYPOINT M membrane dryer and on
the device itself. Do not use any liquid sealants.
3