Husqvarna K 7000 Manuel D'utilisation page 20

To do a check of the RCD
1. Start the product, refer to
page 21 .
2. Look into the inspection holes and push the RCD
test button.
3. Make sure that the RCD moves and that it
disconnects the product from the power supply.
4. Turn the RCD reset knob to reset the RCD.
To connect the water supply
CAUTION: Always use water when you
operate the product. The temperature of the
product is decreased by water also during
dry cutting.
CAUTION: Use correct water pressure to
keep the diamond blade core and segments
cool when you cut. Diamond blades for wet
cutting cannot be used dry.
1. Connect the water hose to the water supply. Refer to
Technical data on page 25 for the lowest permitted
water flow.
20
To start the product on
2. Push the power trigger lockout to open the water
valve.
3. Adjust the water flow with your thumb during the
operation.
To dry cut
CAUTION: Diamond blades for dry cutting
are recommended only for intermittent
operation.
CAUTION: Always use sufficient airflow
around the cutting blade to decrease the
temperature.
1. Turn the button 180˚ to adjust the direction of the
water.
1448 - 003 - 13.02.2020