Error Management - Elinchrom ELB 400 Manuel D'utilisation

User Manual

ERROR MANAGEMENT

ERROR
NUMBER
EN
1
3
4
15
60
90
2
11
61
8
DESCRIPTION
Capacitor over voltage
Discharge timeout error
Charge timeout error
Temperature sensor error
Communication bus error
Safety stop system (generic error)
System over heat
Battery low
Battery unseal error
SOLUTION
Switch the unit off, wait 2 minutes
and switch the unit on again. If the
error shows up again the unit
requires a check up at an authorized
Elinchrom service centre.
Wait until the unit has cooled down.
The unit will switch back to the
normal operation as soon as the
temperature decreases to a normal
working level.
The unit has detected a mains
supply fault. Please check the
mains/battery supply. It could be
not working correctly.
Switch the unit off, wait 2 minutes
and switch the unit on again. If the
error shows up again the battery
requires a check up at an authorized
Elinchrom service centre.