Audio; Flash Mode; Sequence Setup - Elinchrom ELB 400 Manuel D'utilisation

AUDIO

The audio options give you the choice of different settings for when the capacitors are 100%
charged and the unit is ready to flash.
DISPLAY
AUDIO
The volume of the ready, error and key tones can be adjusted, enabling you to work silently if
necessary. The ready tone can be chosen to improve acoustical recognition for when all flashes
have fired and have recycled.

FLASH MODE

The flash mode menu enables you to configure your ELB unit to suit your style of shooting.
DISPLAY
FLASH MODE
The flash before ready feature gives you the choice between flashing the unit before full recycle
or to be able to flash only when the unit has fully recycled.
Stay on default if you wish to do everyday flash photography.

SEQUENCE SETUP

Use sequence mode to catch a moving sequence with a number of indexed units, for example,
of a jumping person in up to 20 different images. The following setup must be programmed in
order to use the features.
• unit address : Every unit requires its own address; every time a trigger is released the
corresponding flash unit will respond. Up to 20 units can be addressed.
• total units : Indicates the total number of addressed flash units.
• sequence timeout : Time after which the sequence restarts back to first addressed unit.
The timeout can be programmed from 0.1s to 5s. This setting is necessary to flash the
addressed units in the right order.
OPTIONS
ready volume
error volume
key volume
ready tone
OPTIONS
flash before ready
default
sequence
delayed
strobo
Setup the activated mode
User Manual
SUB-OPTIONS
From "off" to "max"
From "off" to "max"
From "off" to "max"
From "tone 1" to "tone 2"
SUB-OPTIONS
disabled / enabled
unit address / total units/ seq.
timeout
set delay (in ms)
frequency / duration
EN
5