Operation; On/Off Switch - Haussmann 58485004 Manuel De L'utilisateur

Refer to Figures 8 and 9.
DESCRIPTION
The HAUSSMANN Oscillating Spindle Sander makes
sanding irregular shapes and curves in wood easy and
convenient.
Sander features a large 18" cast iron table, dust port and
on-board storage of drums, inserts and washers.
Six sizes of drums are included.
WARNING
Operation of any power tool can result in foreign objects
being thrown into the eyes, which can result in severe
eye damage. Always wear safety goggles complying with
United States ANSI Z87.1 (shown on package) before
commencing power tool operation.
CAUTION: Always observe the following safety
precautions.
SAFETY PRECAUTIONS
• Whenever adjusting or replacing any parts on the tool,
turn switch OFF and remove the plug from power
source.
• Make sure all guards are properly attached. All guards
should be securely fastened.
• Make sure all moving parts are free and clear of any
interference.
• Make sure all fasteners are tight and have not vibrated
loose.
• With power disconnected, test operation by hand for
clearance and adjust if necessary.
• Always wear eye protection or face shield.
• After turning switch on, always allow drum to come up
to full speed before sanding.
• Be sure drum turns clockwise.
• Avoid kickback by sanding in accordance with the
directional arrows.
• Keep your hands clear of abrasive sleeve and drum.
• For optimum performance, do not stall motor or reduce
speed. Do not force the work into the abrasive.
• Always support workpiece with table.
• Never push a sharp corner of the workpiece rapidly
against sleeve. Abrasive backing may tear.
• Replace abrasives when they become worn (glazed)
or frayed.
• Never use machine for wet sanding which can create a
hazard of electrical shock.

OPERATION

ON/OFF SWITCH

Refer to Figure 8.
The ON/OFF switch is located on the upper front right of
the base. To turn the sander ON, pull the switch to the up
position. To turn the sander OFF, push the switch to the
down position.
The sander can be locked from unauthorized use by
locking the switch. To lock the switch:
• Turn the switch to OFF position and disconnect sander
from power source.
• Pull the key out. The switch cannot be turned on with
the key removed.
NOTE: Should the key be removed from the switch at the
ON position, the switch can be turned off but cannot be
turned on again.
• To replace key, slide key into the slot on switch until it
clicks into place.
Figure 8 - Locking Switch in OFF Position
18