Haussmann 58485004 Manuel De L'utilisateur page 17

Refer to Figures 2 - 5.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING
Do not operate machine until it is completely assembled.
Do not operate machine until you have completely read
and understood this manual.
MOUNTING SANDER
Refer to Figure 2.
Choose a suitable location to mount the sander. The
sander must be installed in a place with ample lighting and
correct power supply. To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the
workpiece. There must be enough room that neither
operators nor bystanders will have to stand in line with
the wood while using the tool.
• Sander can be installed on a workbench or a tool stand
using bolts, lock washers and hex nuts.
• Figure 2 shows the base dimensions and mounting
holes.
Figure 2- Base & Mounting Hole Dimensions
(572 mm)
22½"
(349 mm)
13¾"
" Diameter
/
5
16
(7.9 mm)
ABRASIVE SLEEVE INSTALLATION
Refer to Figures 3 and 4.
TO ATTACH 1/2" ABRASIVE SLEEVE
• Place the 1/2" table insert over spindle and onto the
table. The top side of the insert has directional arrows
stamped into the insert.
• Slide sleeve over the spindle.
• Secure sleeve in position with knob.
NOTE: Knob has left hand thread – turn counterclockwise
to tighten, clockwise to loosen. Knob must seat on sleeve
securely so that sleeve will not spin loose on spindle.
Figure 3- Attaching the 1/2" Sleeve
TO ATTACH 3/4" – 3" ABRASIVE SLEEVES
Example: 2"
• Place the 2" table insert over spindle and onto the table.
• Slide 2" sleeve over the 2" drum.
• Slide drum with sleeve onto spindle. Place 2" drum
Figure 4- Attaching 2" Drum with Sleeve
11"
16½"
(279 mm) (419 mm)
ON-BOARD STORAGE
On-board storage is provided for all drums, inserts and
washers.
Figure 5- On-board Storage
16
The top side of the insert has directional arrows
stamped into the insert.
washer on drum and secure drum in position with knob.
Knob and washer must hold drum firmly so that it does
not spin loose on spindle.
Drums with
Sleeves
Knob
Sleeve
Direction Arrow
on Insert
Knob
2" Drum
Washer
Direction Arrow
on Insert
Table Inserts
Drum Washers