Numark AVM01 Manuel D'utilisation Du Propriétaire page 6

Video Fader
This slider controls the Master video output
depending upon the mode selected. The Video
Fader switches the video from Bus A to Bus B
in Wipe and Mix modes. The type of fade or
wipe is determined by the Video Fade Modes
Video Fade Modes and Options
There are two main control sections in this area: the Mode/Fade Type buttons on the left of the Joystick,
and the Function buttons on the right. To learn quickly, start with one Mode/FadeType and learn all the
different Function selections that can be used with it. Then, go to the next Mode/Fade Type.
Settings are saved while changing from one Mode/Fade Type to another. When the power is shut off, the
unit reverts back to the default factory settings.
The Function section applies different effects and settings based on the Mode/Fade Type section.
and Options controls. "PIP" (Picture-In-Picture)
and Key intensity are also adjusted by the
position of this slider. Finally, Auto Fade
speed is set here as described in the "Auto
Fade" section.
Auto Fade
The Auto Fade On button (Shown as button #9
in "Top Panel Overview") toggles Auto Fade on
and off. When the Auto Fade is turned on, the
Video Crossfader controls the speed. When
the Start button is pressed, the fade will start
at the set speed.
6