ToughTech BC 241 D Manuel D'utilisation Et D'entretien page 24

CAUTION: DO NOT USE AUTOMOTIVE
OIL OR 2-CYCLE OUTBOARD OIL.
GB
CAUTION:
- Match your fuel purchases to your
consumption; don't buy more than you will
use in one or two months;
- Store gasoline in a tightly-closed container
in a cool, dry place.
CAUTION - For the mixture, never use a
fuel with an ethanol percentage higher than
10%; gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10 fuel are
acceptable.
NOTE - Prepare only the quantity of mixture
required for immediate use; do not leave fuel in
the tank or a container for a long time. Were
commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be
stored for 12 months.
Alkylate gasoline
CAUTIONS – Alkylate fuels have
different density than normal fuel. Therefore
engines, set with normal fuel, need different
H jet regulation to avoid critical issues. For
this operation it's necessary turned at a
Licensed Service Dealer.
FILLING THE TANK
Stir the mixture well before refuelling.
PREPARING TO WORK
HARNESS
Correct adjustment of the harness permits the
machine to be properly balanced and at an
appropriate height from the ground (Fig. 6).
- Put on the single harness.
- Attach the engine unit to the harness by means
of the snap hook (A, Fig.6)
- Position the hook (16, Fig.1) to obtain the ideal
balance position of the engine.
20
- Adjust the buckle (C, Fig.6A) to position the
engine at the correct height.
STARTING
WARNING! If no implement is fitted the
engine drive shaft is accessible. NEVER start
the engine unit without an implemented
coupled to it. Use of the engine unit without
a coupled implement can cause serious injury
to the user and/or damage to the engine unit.
Before starting the engine, make sure
the implement is coupled correctly and is not
in contact with any objects.
The cutting attachment must not rotate when
the engine is idling. Otherwise contact an
Authorized Service Center to carry out a check
and fix the problem.
WARNING: With the engine running,
always hold the front grip with the left hand
and the rear grip with the right hand. Always
keep your body is to the left of tube. Never
use a cross-handed grip. Left-handers should
follow these instructions too (Fig.2).
Keep a proper cutting stance.
Over exposure to vibrations can result in
blood-vessel or nerve injury to persons
suffering with blood circulation problems. Seek
medical attention if you experience physical
symptoms such numbness, lack of feeling,
reduction in normal strength, changes in the
colour of the skin. These symptoms normally
appear in the fingers, hands or wrists.
Before starting the engine, make sure that the
throttle lever works freely.
WARNING: Follow safety instruction for
fuel handling. Always shut off engine before
fuelling. Never add fuel to a machine with a
running or hot engine. Move at least 3 m from
refuelling site before starting engine. DO
NOT SMOKE!