Accessories - Landi MFL02 Mode D'emploi

front mount snow blade cm. 85 and pair chains. For the assembly of the snow blade , tighten the pin in the fittings connection

ACCESSORIES:

seating and fix it using a "R" pin.
FAULT
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
FAULT
The engine does not start
The engine power goes down
The grass cut is irregular
The cutting bar does not work or the wheels are not turning
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
FAULT CLEARANCE
check the fuel level, if necessary refuel.
check the throttle to be on START position
check the spark-plug connector to be properly attacched
check the spark-plug condition and if necessary replace it
check the fuel valve to be in the opened position (only for the models showing
such feature)
the air filter is dirty – please clean it
sharpen or replace the cutting blade
adjust the cutting bar clearance
adjust the cutting bar cable
check the wheels to be fasten to the shaft
check the position and the transmission belts position and condition : realign
position and/or replace them.
EN
22