Precautions And Operating Instructions - Helvi DISCOVERY 60 Manuel D'instructions

FIG.5
12V/Slow mode for
battery voltage
between 7.4V - 10V
12V/Fast mode for
battery voltage
between 7.4V - 10V

PRECAUTIONS AND OPERATING INSTRUCTIONS

1) Precautions:
a. The supply voltage of the product is 220~240VAC; please make sure that the
mains voltage meets the specifications of the product before using;
b. The charger is suitable for 6V/12V regular and Lead-acid batteries with 5Ah ~
120Ah capacity;
c. Clamp the battery positive pole (+) with the red clip of the output line, and clamp
the negative pole (-) with the black clip; it will report error if the polarity is reverse;
d. Before charging the battery, in order to prevent the equipment connected to the
battery from damage or unnecessary influence, disconnect the battery and the
equipment before charging the battery;
2) Operating instructions:
A. Connection and reverse polarity: select the battery to be charged, verify the input
voltage and then insert the power plug, enter into the initialization interface as fol-
lows Fig. 6; clamp the red clip of the output side to the positive (+) of the battery, and
Process will be stopped if
the voltage is <9V after 2
mins charging
If the voltage is still <10V
after 9 hours charge display
error message
Press the button to
select the mode:12V/
Slow.12V/Fast, 12V/
Low Temp and pause
the charging.
Process will be stopped if
the voltage is <9V after 2
mins charging
If the voltage is still <10V
after 9 hours charge display
error message
Press the button to spause
the charging.
Flash at 1Hz
alternately
Flash at 1Hz
alternately
15
Press the button to
restart the process
Press the button to
restart the process