How To Route Cables - Pioneer PDP-S34-LR Mode D'emploi

2 How to route cables

Speed clamps and bead bands are supplied for bunching cables. Once properly bunched, follow the steps below to route the
cables.
When the speakers are installed on the sides
The below rear view shows
Speaker cable
Attaching speed clamps to the main unit
Attach the speed clamps using any of the 5 holes you prefer
marked with below, depending on your routing system.
flush
mounting, however cable routing for set back mounting will be the same.
Bead band
Speed clamps
Attaching and removing speed clamps
Insert 1 into an appropriate hole on the rear of the Plasma
Display and snap 2 into the back of 1 to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
To remove, use pliers to twist the clamp 90°, pulling
outward. The clamp may deteriorate over time and become
damaged if removed.
1
2
Bunching and securing cables with the
bead bands.
Do not allow excessive stress to be placed on the ends of
cables.
English
Speaker cable
5