Before Using For The First Time; Boiling Water; Cleaning And Maintenance - Bosch TWK 7902 Mode D'emploi

en
Before using
for the first time
● Remove any stickers or film.
● Unroll the right amount of cable from the
cable tidy 7 and plug it in.
● Fill the kettle 1 with water. Bring the
water to a boil and discard it. Repeat the
procedure. This will make sure that the
kettle is clean for normal use.
● When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Boiling water
● Fill the kettle with fresh water through the
spout or the open lid 2 (press lid release
button 3).
● Read the quantity on the water level
indicator. Do not fill with less than
0.25 litres or more than 1.7 litres of water!
● Close the lid 2 until it locks and place the
kettle 1 on the base 6.
● Press down the switch 4; the switch lights
up. The water is heated.
● The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off
at any time by pulling up the ON/OFF O
switch 4.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.: Only operate the kettle with the lid 2
closed and the limescale filter 5 inserted,
otherwise the kettle will not switch off.
For physical reasons, the base 6 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.
Cleaning and
maintenance

Risk of electric shock
!
Never immerse the device in water or place
it in the dishwasher!
Do not steam-clean the appliance.
● Before cleaning, unplug the appliance
from the power outlet.
● Clean the outside of the kettle 1 and base
6 with a damp cloth. Do not use strong or
abrasive cleaning agents.
● Remove the limescale filter 5, soak it in a
little vinegar, then rinse clean with clear
water.
● Rinse the kettle 1 and the limescale filter
5 with clear water.
Descaling
Regular descaling
– makes your kettle last longer;
– ensures proper function;
– saves energy.
Descale the kettle 1 with vinegar or a
commercial descaling agent.
● Fill the kettle 1 with water up to the 1.7
mark and bring to a boil. Next, add a
small amount of white vinegar and let it
sit for several hours. You can also use a
commercial descaling product and follow
the manufacturer's instructions.
● Rinse the kettle 1 and the limescale filter
5 with clear water.
Attention: Never use hard objects to
remove limescale residue as this will
damage the seal.
3
TWK7902 03/2013