Parts And Operating Controls; Boiling Water; Before Using For The First Time - Bosch TWK 740 Serie Mode D'emploi

Masquer les pouces Voir aussi pour TWK 740 Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you
a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid
3 Lid opening button
4 On/Off switch, illuminated
5 Limescale filter (removable)
6 Base
7 Cable tidy
Important: Use the kettle 1 only with its 
included base 6.
  ● Only fill the kettle with water. Milk and 
instant beverages will burn and damage 
the appliance. Never operate the kettle 
1 without water and do not overfill it; 
observe the min and max markings. If 
the kettle is too full, the water will boil 
over! 
Before using
for the first time
  ● Remove any stickers or film.
  ● Unroll the right amount of cable from the 
cable tidy 7 and plug it in.
  ● Fill the kettle 1 with water. Bring the water 
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is 
clean for normal use.
  ● When the water comes to a boil for the 
first time, add a tablespoon of white 
vinegar.
8
All manuals and user guides at all-guides.com

Boiling water

  ● Fill the kettle 1 with fresh water, either 
  ● Read the quantity on the water level indi-
  ● Close the lid 2. 
  ● Press down the switch 4; the switch lights 
  ● The kettle switches off automatically once 
The appliance can also be switched off at 
any time by pulling up the switch 4.
Warning: If you remove the kettle 1 from 
the base and replace it before the heating 
process is over, the kettle will not continue 
to heat the water. 
N.B.: Only operate the kettle with the lid 2 
closed and the limescale filter 5 inserted, 
otherwise the kettle will not switch off.
For physical reasons, the base 6 may 
collect some condensation water. This is 
normal; it does not mean that the kettle 1 
leaks.
After boiling, let the kettle cool down for 
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1 
is empty, otherwise the overheat control will 
engage and the appliance will switch itself 
off automatically.
through the spout or by pressing the 
opening button 3 to open the lid 2.
cator. Do not fill with less than 0.3 litres or 
more than 1.7 litres of water!
up. The water is heated.
the water has boiled.

Publicité

Table des Matières
loading

Table des Matières