Novy MA7510 Instructions D'installation page 13

the four mounting cables and insert them into the holes of the mounting plates and pull them through the slot down-
wards, as shown in the figure. The height adjustment will be dealt with later.
4
Electrical connection:
Slide the closing plate over the mounting cables until it almost touches the mounting plate. Connect the power sup-
ply cable to the connector. Replacement of the connection cable is to be done by a qualified installer. The amperage
and the energy consumption have been indicated on the specification label attached to the inside of the hood.
5
Slide both closing plates over the cables until they touch the mounting plates. Attach each closing plate with two
screws (906147) into the mounting plate.
6
Adjust the height:
- The height of the hood with respect to the ceiling can be between 250 and 1500 mm.
- The recommended mounting height for an electrical or ceramic cooking plate is min. 600 mm and max. 850 mm.
- The mounting height for a gas or induction cooking plate is min. 650 mm and max. 850 mm.
The cable clamps are found at the place where the cable enters the hood. The cable can be extended by pressing
this cable clamp. The cable will be locked as soon as the cable clamp is no longer pressed. The cable can still be slid
in at this moment. The visible length of the power supply cable can be adjusted by sliding it into the hood.
While adjusting the cables, support the hood in order to prevent it from falling.
Do not exceed the maximum height to the ceiling (1500 mm).
Optionally, an accessory with four longer cables of 3,5 metres can be ordered (item number 7500100).
EN 13