Hoover Vision Reach Manuel D'utilisation page 7

CHanging THE BELT Or BrUSHES
If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first
please make sure you have:
• Emptied the bin
• Cleaned the filters
• Checked for blockages
Turn the cleaner over and remove 6
1
retaining screws attaching the brush guard
to the base.
Remove the brush guard.
2
3
Remove brush assembly and check for
wear on the belt.
Loop the new belt around the motor and
brush channel.
iMPOrTanT: Switch the cleaner off and
remove the plug from the electricity supply
before attempting any maintenance.
Hold the brush assembly and stretch the
4
belt until the brush can be slotted back
into the cleaner housing.
Rotate the brush to ensure free movement
5
of the belt.
Refit the brush guard with 6 retaining screws.
6
- 7 -
CLEaring a BLOCKagE
iMPOrTanT: Switch the cleaner off and
remove the plug from the electricity supply
before attempting any maintenance.
Check the cleaning
tools and hose for
blockages.
The hose can be
removed at both ends.
Turn the cleaner
over and rotate the
brushes to identify any
obstructions including
hair.
Check for a blockage in
the hose socket. Use a
flexible rod to remove
any obstruction.
To clear a blockage in
the Pet Hair & Allergen
Remover*, twist the collar
at the rear and lift the
cover.
*Certain models only
gB