Warn 90288 Guide D'installation Et Operateur page 5

OVERVIEW
The WARN Wireless Control gives you the ability to operate the
winch using a wireless hand held remote. The wireless control
system integrates with the standard handlebar switch and
remote so that the operator may use either the wired or wireless
controls at any time.
To use the wireless system, the operator first activates the
system by pressing and holding both buttons on the wireless
remote for 3 seconds. This transfers control of the winch to
the wireless control system. The GREEN indicator light on the
handheld remote glows when the system is active and ready to
use. Deactivate the system by pressing both buttons on the
wireless transmitter simultaneously and holding for 3 seconds
until GREEN light turns off.
After 2 minutes of idle time, the wireless system de-activates.
SAFETY
When installing your winch and winch control system, read and
follow all mounting and safety instructions. Always use caution
when working with electricity and remember to verify that no
exposed electrical connections exist before energizing your
winch circuit.
SPECIFICATIONS
Part number for complete system:
PN 90288
Transmission range:
15-27 m (50-90 ft.)
Receiver Operating voltage:
12 to 24 VDC
Receiver Fuse type and current rating:
ATC 7.5 amp
Batteries for hand held remote:
two alkaline, 12 volt, type 23
WIRELESS CONTROL
KIT INCLUDES:
Wireless Receiver/ Wiring Harness (1)
Wireless Transmitter (1)
Holster Assembly (1)
4
STEP 1: MOUNT ALL WINCH
COMPONENTS
First install the winch and other components including the
contactor, handlebar switch, and socket for wired remote
(optional on some models). Then install the wireless control
system.
Location for these components may differ from the illustration
depending on make and model of the ATV. Read and understand
the instructions to choose the appropriate mounting locations.
Socket for standard remote
Winch
Handlebar mounted
control switch
Electrical contactor
5