Beta 1933 Notice D'utilisation page 11

PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING PNEUMATIC TOOL
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR HEARING PROTECTION WHILE OPERATING PNEUMATIC TOOL
ALWAYS WEAR EYE PROTECTION WHILE OPERATING PNEUMATIC TOOL OR PERFORMING
MAINTENANCE JOBS
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING
PNEUMATIC TOOL
ALWAYS WEAR SAFETY SHOES
Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk analysis survey if
the values exceed the limits under current regulations.
WEAR ANTI-VIBRATION GLOVES WHILE OPERATING PNEUMATIC TOOL FOLLOWING A
SPECIALLY CONDUCTED SURVEY OF LEVEL OF DAILY EXPOSURE OF HAND-ARM SYSTEM TO
VIBRATION
WEAR PROTECTIVE MASK AGAINST PHYSICAL AGENTS
WEAR PROTECTIVE HELMET
TECHNICAL DATA
FREE SPEED
CHUCK CAPACITY
POWER
AIR INLET
MAXIMUM PRESSURE
MINIMUM INTERNAL HOSE SIZE (ø)
MEAN AIR CONSUMPTION
WEIGHT
OVERALL LENGTH
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
VIBRATION LEVEL
KEY TO SYMBOLS
a: wheel rotation spindle
b: wheel chuck Ø 3-6 mm
c: spindle nut
d: open end wrench
e: grinding wheel
INSTRUCTIONS
Air supply connection
For correct use of the pneumatic tool, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the
pneumatic tool with clean, condensate-free air (picture 4-i). Excessively high pressure or humidity in supply air results in shorter life for
the mechanical parts and may damage the tool.
25,000 rpm
Ø 3-6 mm
0.20 kW
1/4" GAS
6.2 bars
10 mm
230 l/min
0.380 kg
159 mm
80.0 dB(A) (EN ISO 15744)
87.0 dB(A) (EN ISO 15744)
2
4.53 m/s (ISO 28927-2)
f: safety lever
g: grinder start lever
h: oil lubrication
i: air inlet 1/4" GAS
l: wheel speed regulation
m: air outlet