AEI Security & Communications DigiSender XD Mode D'emploi page 9

DGXDSDV111 - DigiSender® XD - Single Input Digital Wireless AV Sender System
continued...
5.
The DigiSender® XD Boot Screen will be displayed
whilst the Receiver locks on to the Transmitters
signal.
7.
You will notice that at the top right corner of the
screen is a blue Diagnostics Bar with some infor-
mation on it. If the Diagnostics Bar is not present,
then your Receiver may not be in Diagnostics Mode.
Flick the Mode Switch on the back from Normal to
Diagnostics and turn the receiver off and then back
on again.
Please read the instructions carefully prior to installation
6.
After approximately 5 seconds the picture will
change to whatever you are transmitting. If the pic-
ture does not change, or changes to the DigiSender®
Test Card, you may need to re-sync the Transmitter
and Receiver. See page 12 for more details.
8.
The first number indicates the Frame Rate that the
Receiver is picking up from the Transmitter and out-
putting to your TV.
ENGLISH (EN)
Page 09