Step 4 - Install The Receiver - AEI Security & Communications DigiSender XD Mode D'emploi

DGXDSDV111 - DigiSender® XD - Single Input Digital Wireless AV Sender System
Installing your DigiSender® XD

Step 4 - Install the Receiver

The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
1.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® XD SCART
cable.
3.
Connect the PSU to an available mains socket. The
Power Indicator will light up Red to indicate that the
unit is in Standby Mode.
Please read the instructions carefully prior to installation
2.
Connect the PSU to the socket labelled '5V ~ 1.0A'
on the Receiver.
ENGLISH (EN)
Page 07