General Information - Daikin EKHH2E200AAV3 Manuel D'installation Et D'utilisation

Masquer les pouces Voir aussi pour EKHH2E200AAV3:

Table des Matières

Les langues disponibles

To change the minutes:

Press and release the

key while changing the

time: the display will show "nn" followed by the two

numbers representing the minutes;

Press and release either the

within 15 seconds;

Press and release the

key or do not carry out

any operations for 15 seconds;

To exit the procedure:

Press and release the

key until the display

shows the temperature established by parameter

P5 or do not carry out any operations for 60

seconds.

Alternatively:

Press and release the

key.

To set operations within timeslots, it is

necessary to have carried out the settings

relating to the day and the real time

beforehand.

8.1.3.15 Configuration parameter settings

To carry out the procedure:

Make sure that the keyboard is not locked

(paragraph 8.1.3.3) and that no other advanced

procedure is in progress;

Keep the

and the

keys pressed for

4 seconds: the display will show "PA" (password);

Press and release the

key;

Press and release either the

within 15 seconds to set "-19" on the display;

Press and release the

key or do not carry out

any other operations for 15 seconds;

Keep the

and the

keys pressed for

4 seconds: the display will show the first

parameter "SP1".

To select a parameter:

Press and release either the

To change a parameter:

Press and release the

key;

Press either the

or the

increase or reduce the parameter value (within 15

seconds);

Press and release the

key or do not carry out

any operations for 15 seconds.

To exit the procedure:

Keep the

and the

keys pressed for 4

seconds or do not carry out any operations for 60

seconds (any changes will be saved).

Switch the equipment off and then back on

again to make the changes made to the

parameters effective.

Installation and user manual

8.1.3.16 Restoring default factory settings

To carry out the procedure:

Ensure that the keyboard is not locked (paragraph

8.1.3.3) and that no other advanced procedure is

or the

key

in progress;

Keep the

4 seconds: the display will show "PA" (password);

Press and release the

Press and release either the

within 15 seconds to set "149";

Press and release the

any operations for 15 seconds;

Keep the

the display will show "dEF";

Press and release the

Press and release either the

15 seconds to set "1";

Press and release the

any other operations for 15 seconds: the display

will show "dEF" flashing for 4 seconds, after which

the equipment will exit the procedure;

Disconnect the equipment from the mains power

supply.

To exit the procedure before its completion:

Keep the

4 seconds during the procedure (or rather before

setting "1": the restoring of default factory settings

will not be carried out).

or the

key

8.1.3.17 TOTAL OF THE COMPRESSOR

8.1.3.17.1

The equipment is capable of memorising up to 9,999

compressor operating hours, if the number of hours

exceeds "9,999" it flashes.

or the

key.

8.1.3.17.2

Make sure that the keyboard is not locked

(paragraph 8.1.3.3) and that no other advanced

procedure is in progress;

key to either

Press and release the

show "Pb1";

Press and release either the

select "CH";

Press and release the

To exit the procedure:

Press and release the

any other operation for 60 seconds.

Alternatively:

Press and release the

and the

keys pressed for

key;

or the

key or do not carry out

and the

pressed for 4 seconds:

key;

or the

key or do not carry out

and the

key pressed for

OPERATING HOURS