WIKA RLT-1000 Mode D'emploi page 13

5. Commissioning, operation
If the opening of the process connection is too small for the float, the
■
float must be removed before mounting.
- Before removal, mark the position of the float stop  with a
waterproof pen
- Mark the mounting position of the float (e.g. "Up")
- After the level sensor has been mounted, the float should be
re-attached within the inside of the tank (pay attention to the
mounting position!).
- Secure the float stop  again at the marked point.







WIKA operating instructions models RLT
≤ 30°
EN
13