Compound Cutting - Makita DLS600 Manuel D'instruction

Compound cutting

Compound cutting is the process in which a bevel
angle is made at the same time in which a miter angle
is being cut on a workpiece. Compound cutting can be
performed at the angle shown in the table.
Miter angle
Left and right 45°
Right 52°
Left 52°
When performing compound cutting, refer to "Press
cutting", "Miter cutting" and "Bevel cut" explanations.
Cutting aluminum extrusion
3
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion 5. Spacer block
When securing aluminum extrusions, use spacer blocks or pieces
of scrap as shown in the figure to prevent deformation of the alumi-
num. Use a cutting lubricant when cutting the aluminum extrusion
to prevent build-up of the aluminum material on the blade.
CAUTION:
Never attempt to cut thick or round
aluminum extrusions. Thick aluminum extrusions
may come loose during operation and round alumi-
num extrusions cannot be secured firmly with this tool.
Cutting repetitive lengths
When cutting several pieces of stock to the same length,
ranging from 200 mm (7-7/8") to 330 mm (13"), use the
set plate (optional accessory). Install the set plate on the
holder (optional accessory) as shown in the figure.
► 1. Set plate 2. Holder 3. Screw
Bevel angle
Left and right 0° - 45°
Left 20° - Right 45°
Left 45° - Right 20°
1
2
4
5
1
3
Align the cutting line on your workpiece with either the
left or right side of the groove in the kerf board, and
while holding the workpiece, move the set plate flush
against the end of the workpiece. Then secure the set
plate with the screw.
When the set plate is not used, loosen the screw and
turn the set plate out of the way.
Carrying tool
WARNING:
and storage purposes and should never be used
for any cutting operations. The use of the stopper
pin for cutting operations may cause unexpected
movement of the saw blade resulting in kickback and
serious personal injury.
CAUTION:
before carrying the tool. If portions of the tool move
while being carried loss of control or balance may
occur resulting in personal injury.
1.
Remove the battery cartridge.
2.
Secure the blade at 0° bevel angle and the turn
base at the full right miter angle position.
► 1. Turn base
3.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
4. Carry the tool by holding the handle.
2
20 ENGLISH
Stopper pin is only for carrying
Always secure all moving portions
1