Electric Brake; Hex Wrench Storage - Makita DLS600 Manuel D'instruction

Aligning the laser line
Align the cutting line on your workpiece with the laser line.
A) When you want to obtain the correct size on the left side
of workpiece, shift the laser line to the left of the blade.
B) When you want to obtain the correct size on the right side
of workpiece, shift the laser line to the right of the blade.

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop the blade after the
switch trigger is released, have the tool serviced at a
Makita service center.
CAUTION:
The blade brake system is not a
substitute for the blade guard. Never use tool
without a functioning blade guard. An unguarded
blade may result in serious personal injury.
ASSEMBLY
WARNING:
Always be sure that the tool is
switched off and the battery cartridge is removed
before working on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury.

Hex wrench storage

The hex wrench is stored as shown in the figure. When the hex
wrench is needed it can be pulled out of the wrench holder.
After using the hex wrench it can be stored by returning
it to the wrench holder.
► 1. Wrench holder 2. Hex wrench
B
A
1
Installing or removing saw blade
WARNING:
switched off and the battery cartridge is removed
before installing or removing the blade. Accidental
start up of the tool may result in serious personal
injury.
CAUTION:
provided to install or remove the blade. Failure
to do so may result in overtightening or insufficient
tightening of the hex socket bolt. This could cause
an injury.
To remove the blade, perform the following steps:
1. Release the stopper pin, and then lock the handle
in the raised position by pushing in the stopper pin.
► 1. Stopper pin
2. Use the hex wrench to loosen the hex socket bolt
holding the center cover by turning it counterclockwise.
Then, raise the blade guard and center cover.
2
3
2
► 1. Center cover 2. Hex socket bolt 3. Hex wrench
4. Blade guard
16 ENGLISH
Always be sure that the tool is
Use only the Makita hex wrench
1
1
4