Fleetsync: Alphanumeric 2-Way Paging Function; Selcall (Selective Calling); Status Message - Kenwood NEXEDGE NX-700 Mode D'emploi

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION

FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by
JVC KENWOOD Corporation.
Note: This function is available only in analog operation.

SELCALL (SELECTIVE CALLING)

A Selcall is a voice call to a station or group of stations.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status to enter Selcall mode.
3 Press /
• If you are using a microphone keypad and Manual Dialing is enabled, you can
directly enter the station ID.
4 Press the PTT switch and begin your conversation.
■ Receiving
An alert tone will sound and the transceiver will enter Selcall Mode. The calling
station's ID will appear when a Selcall is received. You can respond to the call
by pressing the PTT switch and speaking into the microphone.
■ Identifi cation Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver has its own ID.
• Enter a Fleet number (100 ~ 349) to make a fl eet call.
• Enter an ID number (1000 ~ 4999) to make an individual call in your fl eet.
• Enter a Group ID (which is programmed in the FPU) to make a group call.
• Enter a Fleet number followed by an ID number to make an individual call in your
desired fl eet (Inter-fl eet call).
• Select "ALL" Fleet and "ALL" ID to make a call to all units (Broadcast call).
• Select "ALL" Fleet and enter an ID number to make a call to the selected ID in all
fl eets (Supervisor call).

STATUS MESSAGE

You can send and receive 2-digit Status messages which may be decided in your
talk group. Messages can contain up to 16 alphanumeric characters. Status
messages range from 10 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status messages and short
messages) can be stored in the stack memory of your transceiver.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status mode (proceed to
step 5) or Selcall + Status to enter Selcall mode (proceed to step 3).
14
to select the station you want to call.