Short/Long Messages; Gps Report - Kenwood NEXEDGE NX-700 Mode D'emploi

3 Press /
• If Manual Dialing is enabled, you can enter the station ID by using the
microphone keypad, or by using
to select a digit, then press
Repeat this process until the entire ID is entered.
4 Press to enter Status mode.
5 Press /
• If Manual Dialing is enabled, you can enter the status ID by using the microphone
keypad, or by using
6 Press the PTT switch or
• "<<COMPLETE>>" appears on the display when the status has been
successfully transmitted.
■ Receiving
The icon will fl ash and a calling ID or text message will appear when a
Status call is received. Press any key to return to normal operation.
■ Reviewing Messages in the Stack Memory
1 Press the key programmed as Stack, or press and hold the key
programmed as Selcall, Status, or Selcall + Status to enter Stack mode.
• The last received message is displayed.
2 Press /
• Message types are identifi ed as follows:
I: Caller ID, S: Status Message, M: Short Message
• Press and hold
ID Name > Status/Short Message > CH/GID > Time Stamp
3 Press to return to normal operation.
• To delete the selected message, press
or .
• To delete all messages, press and hold
deletion, press

SHORT/LONG MESSAGES

Received short messages are displayed the same as Status messages and are
stored in the same stack memory.
To send short messages, and to send and receive long messages, you must
connect the transceiver to a PC. Ask your dealer for details.

GPS REPORT

To send your location data, you must fi rst connect a GPS unit to the transceiver.
GPS data can be manually transmitted by pressing the key programmed as Send
the GPS data, or by accessing the Menu {page 9}. If set up by your dealer, GPS
data may be automatically transmitted at a preset time interval.
to select the station you want to call.
to select the status you want to transmit.
/ (refer to step 3, above).
to initiate the call.
to select the desired message.
for 1 second to cycle the display information as follows:
or .
/ . When using
to set the digit and move the cursor to the right.
or #. To confi rm the deletion, press
or # for 1 second. To confi rm the
/ , cycle through the digits
15