Operating Tq-400, -800, -1200, And -1800 Series - Hatco Toast Qwik TQ-10 Série Manuel D'installation Et D'utilisation

English
Operating TQ-400, -800, -1200, and -1800
Series
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. move the Power ON/OFF (I/O) switch in the ON (I) position.
3. adjust the TOP HEaT and/or BOTTOm HEaT controls.
• For two sided toasting, turn the TOP HEaT control and
BOTTOm HEaT control clockwise to the highest setting.
• For one sided toasting, turn the TOP HEaT control
clockwise to the highest setting and turn the BOTTOm
HEaT control counter-clockwise to the lowest setting.
NOTE: TQ-400BA, -800BA, -800HBA, -1800BA, and -
1800HBA toasters are designed specifically for toasting
one side of a bread product, such as a bun or bagel.
These models toast with the cut side facing up.
NOTE: When toasting a single-sided product such as a bun or
bagel, place the product with the cut side facing up.
Adjust the BOTTOM HEAT control to a light setting,
toast two slices of bread product and adjust the TOP
HEAT and/or BOTTOM HEAT controls as needed.
Warning Light
BOTTOM HEAT
Control
Warning Light
BOTTOM HEAT
Control
Form No. TQ2m-0414
TOP HEAT
Control
Control Panel – TQ-400, -800, -1200, and -1800 Series, Single-Sided Toaster
TOP HEAT
Control
Control Panel – TQ-400, -800, -1200, and -1800 Series, Two-Sided Toaster
4. Turn the COLOR CONTROL to the lowest position while
the toaster heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up
period.
5. after warm-up period, toast two slices of bread product.
adjust the COLOR CONTROL if needed.
NOTE: If toasted bread product is too dark with the COLOR
CONTROL set on the lightest setting, adjust the TOP
and/or BOTTOM HEAT controls as needed. (Allow 15 to
20 minutes for toaster to re-adjust to new setting before
resuming operation.)
NOTE: To toast moist products such as English Muffins, rye
bread or whole wheat, slow the conveyor by turning the
COLOR CONTROL knob to a darker setting (clockwise).
IMPORTANT NOTE
If the Warning light comes on, the unit may be overheating.
Turn off and unplug the unit. Refer to the "Daily Cleaning"
procedure to clean the cooling fan vents. If the unit does not
function properly after cleaning the cooling fan vents, contact
an authorized Service agent or Hatco for assistance.
POWER SAVE
Button
COLOR CONTROL
POWER SAVE
Button
COLOR CONTROL
13
OPERATION
Power ON/OFF
(I/O) Switch
Power ON/OFF
(I/O) Switch