Philips GC7000 Série Mode D'emploi page 8

ENGLISH
10
Problem Possible cause
The Calc-Clean You have not pressed
process does not the Calc-Clean button
start. for 2 seconds until the
appliance started
beeping.
The iron leaves a The surface to be
shine or an ironed was uneven, for
imprint on the instance because you
garment. were ironing over a
seam or a fold in the
garment.
The ironing board Steam has condensed
cover becomes on the ironing board
wet or water cover after a long
droplets come ironing session.
out of the
soleplate.
You may have an
ironing board that is
not designed to cope
with the high steam
rate of the steam
generator.
Steam continues Steam is generated in
to come out after the soleplate. When
I release the you release the steam
steam trigger. trigger, remaining
water is transformed
into steam. This is
normal.
There is a strong When the iron is tilted
gush of steam upwards, remaining
when I release water is collected and
the steam trigger converted into strong
after placing the steam. This is normal.
iron on the iron
platform.
Steam is weak. You do not press the
steam trigger
continuously.
Solution
See chapter 'IMPORTANT - Cleaning
and maintenance' .
Perfect Care is safe on all garments.
The shine or imprint is not
permanent and will disappear when
you wash the garment. Avoid ironing
over seams or folds or you can place
a cotton cloth over the area to be
ironed to avoid imprints.
Replace the ironing board cover if
the foam material has worn out. You
can also add an extra layer of felt
material under the ironing board
cover to prevent condensation on
the ironing board.
Put an extra layer of felt material
under the ironing board cover to
prevent condensation on the ironing
board.
Release the steam trigger 2 to 3
seconds before you place the iron
back on the iron platform or ironing
board.
Release the steam trigger 2 to 3
seconds before you place the iron
back on the iron platform or ironing
board.
Keep the steam trigger pressed
continuously when you move the
iron over the fabric.