Sony WAHT-SA1 Mode D'emploi page 10

Note
• If you perform the pairing operation between the
surround amplifier and another S-AIR main unit,
sound transmission established by the ID is
canceled.
• Pairing will not be canceled unless you change
the ID setting.
Tip
• To press the PAIRING button, a slim instrument,
such as a paper clip, can be used.
Attaching the cover to
the surround amplifier
After connecting, you can attach the cover
to the surround amplifier to organize and
store excess speaker cords.
1
Attach the speaker cord cover by
sliding it down along the grooves
on the edges of the surround
amplifier.
Surround
amplifier
Push the speaker cord cover down until
you hear a click. Turn the surround
amplifier upside down, and store the
cords in the speaker cord cover.
10
GB
Speaker cord cover
Grooves
2
Insert the tabs of the speaker
cord holder in the slots of the
speaker cord cover, and press it
into place.
Surround
amplifier
m
Note
• When detaching, remove the speaker cord
holder, then remove the speaker cord cover. To
remove the speaker cord holder, slightly press
the catch of the holder and lift off. To remove the
speaker cord cover, slightly splay open the edges
of the cover and slide down.
• Do not use excessive force to store the cords.
Speaker cord holder