To A Car Battery; Use - AEG 10057 Mode D'emploi

To a car battery

Warning!
Risk of short circuits! Always observe the correct
polarity. Avoid short circuiting the battery poles.
1. unscrew the red and black terminal screw at the
back of the device.
2. Place the red cable with the lug (12) and the
washer onto the red terminal (1) and screw tight
with the red terminal screw.
3. Place the black cable with the lug (11) and the
washer onto the black terminal (2) and screw
tight with the black terminal screw.
4. Connect the red cable with clamp (12) to the
positive battery terminal (marked „P" or „+").
5. Connect the black cable with clamp (11) to the
negative battery terminal (marked „N" or „-").

uSE

Attention!
Some external devices, especially radios and/or
other audio and chargeable devices can damage
the power inverter and/or the connected external
appliance.
Check to see whether the external appliance con-
nected to the power inverter "hums", overheats
or heats excessively up in the first few minutes. If
this is the case, disconnect the external appliances
and all cables immediately. In this case the external
appliance are incompatible and cannot be operated
with each other. If anything should be unclear, con-
sult the dealer of the external appliance.
You can use both 230 V sockets (5) and the USB
port (9) simultaneously.
The total rated voltage for external devices con-
nected to the 230 V socket and the uSB port must
not exceed the rated power of the voltage converter
(see „Technical Data").
Note:
•
The power rating of an external device is indi-
cated on the technical label which is affixed to the
particular external device. External devices such
as electric motors, e.g. drills, electric saws, refrig-
erators and music systems usually have a greater
power rating at the start up than is specified on
the technical label.
•
If the power rating is only given in Amps, simply
multiply the A value by the factor 230 to obtain
the equivalent in Watt.
For example: 0.4 A x 230 = 92 Watts
•
Remember the vehicle's battery will be discharged
when the vehicle is not running.
Switching the voltage converter on/off
Set the On/Off switch (10) to ON.
If the green LED (8) lights up, the voltage converter
is ready for use.
Using the 230 V socket
Only use external devices with Schuko plug or
European cable connectors.
1. Switch on the voltage converter.
2. Connect the plug of an external device to the
230 V socket (5) on the voltage converter.
Using the 2.0 USB output socket
1. Switch on the voltage converter.
2. Plug an external uSB device into the uSB
port (9).
The uSB output on this power inverter provides a
power supply of 5 V DC for external USB devices
(e.g. lights, fans, radios).
Note:
•
The uSB output on the power inverter is not
designed for transferring data.
•
Do not connect memory sticks, MP3 player or
similar data storage external appliances.
Using the cordless remote control module
you can control the voltage converter with the cord-
less remote control module (13).
1. Press the On/Off switch (14) on the cordless
remote control module (13) to switch off the
sockets.
2. Press the On/Off switch (14) again to switch the
sockets on.
Note:
The voltage converter can only be controlled with
the cordless remote control module (13) when the
On/Off switch (10) is set to ON.
English 25