Sterilization At Start-Up; Sensor Range; Buzzer - WLD-TEC Sterimax smart Mode D'emploi

By briefly touching the timer symbol (2), the user can scroll through the individual menu
items:
Settings menu:
ES - Sterilization at start-up ON / OFF
SE - Sensor range 1 - 8
SU - Buzzer ON / OFF
SA - Stand-by time 15, 30, or 60 minutes
AL - Insertion mode ON / OFF
W - Factory default settings
Exit the settings menu by briefly pressing the button (14) on the back of the device.
After selecting the settings menu, if the settings are not changed within 10
i
seconds it automatically returns to the main display.
If the "Settings Menu" (14) button is pressed during sterilization, the sterilization
process is stopped and the settings menu is called up.

4.2 Sterilization at start-up

This is used to sterilize the annealing tube after switching on the device.
The configured sterilization time is used. The settings menu is activated
by briefly pressing the button (14) on the back of the device.
Then select "ES" setting by briefly touching the timer symbol (2).
Keep the timer symbol (2) pressed and select ON ("1") or OFF ("-") by
releasing.
(Factory setting: OFF = "-")

4.3 Sensor range

In this menu item, the sensor range can be set to 8 different levels. This
function is useful to match activation of the sensor to the length of the
instruments. The settings menu is activated by briefly pressing the
button (14) on the back of the device.Then select "SE" setting by briefly
touching the timer symbol (2).Keep the timer symbol (2) pressed and select
range (1 - 8) by releasing. Sensor range Level 1 = near / Level 8 = far.
(Factory setting: Level 4)

4.4 Buzzer

If the buzzer is switched on, an audible signal sounds after the cooling
time has expired. The settings menu is activated by briefly pressing the
button (14) on the back of the device. Then select "SU" setting by briefly
EN
25