Initial Operation; Quartz Glass Annealing Tube; Power Connection; Operation - WLD-TEC Sterimax smart Mode D'emploi

1. Initial operation

Please handle this sterilizer always with care as described in the following points of this
manual.

1.1 Quartz glass annealing tube

Upon delivery, the annealing tube (9) is already installed in the sterilization orifice (9a).
Remove the protective foil and the adhesive warning label before frist use.
!
Never operate the device without the annealing tube (9) in place!

1.2 Power connection

Plug the power cable (20) using the connector (18) into the power socket (16) on the
back of the device. Insert the power plug (19) into a live power outlet suitable for your
device (230V AC, 120V AC or 100V AC).

2. Operation

This section describes switching on and off the device and the touch operation of the
glass front panel.

2.1 Switching on the device

Switch on the device using the power switch (17) on the rear panel
1.
(switch position "I").
For switching on the device, please briefly touch the On / Off symbol (1).
2.

2.2 Switching off the device

The device is switched off by touching the On / Off symbol (1) on
1.
the glass front for more than 2 seconds.
Switch off the device using the power switch (17) on the rear panel
2.
(switch position "0").
When you switch off, the respective settings are saved.
i
Depending on the residual heat, the fans may still be running.

2.3 User selection function

The user can select between "User 1" or "User 2" by briefly touching
the On / Off symbol (1). The current user is indicated by the illuminated
number 1 or 2.
Both user accounts store the respective parameters depending
i
on the user.
22