Santoemma Elite-Silent Manuel D'utilisation Et De Maintenance page 14

technical assistance. The repeated intervening of the protection might result in faults which cannot be
covered by warranty.
4. Lower the vacuum head by pushing on the rudder bar, which is situated on the right-lower side of
the machine.
Attention: Keep an adequate safety distance from other people, who could be run over by the machine.
Pay attention to any object that could be hit by the machine. Never leave the machine unguarded.
To switch on the machine you must act on the switches on the control panel:
PUMP
5. Set to position "I" the switches of the vacuum motor and the rotating brush.
6. Set to position "I" the pump switch. In this way the solution pump works only while the control
lever is pressed down. With the pump switch in position "II", you have a continuous flow, without
having to keep the spray laver pressed.
7. Set the regulation valve on the left-lower part of the machine, in order to regulate the quantity of
water sprayed on the carpet. Screw the knob to reduce the water-flow, and unscrew to increase
the flow. To help the priming of the pump, initially unscrew totally the knob.
Attention: Do not let the pump function without water!
The machine should not be used to vacuum dust, which would be sucked by the vacuum motor,
damaging it. It is possible to vacuum dust with the machine only if you connect the optional accessory
NS270DUST, with the internal filter to collect dust.
I I
O O
O
I I I
VACUUM BRUSH
14
CONTROL
LEVER