Publicité
Les langues disponibles
Les langues disponibles
Knob to regulate
the water-flow
Knob to regulate
the pressure of
the vacuum head
Knob to regulate
the pressure of
the brush
1.
To wash carpet, use the standard vacuum head for carpet. If you need to wash hard floor, you must
use the optional squeegee SQ720, which allows to work on hard floor. The connection between the
machine and the squeegee is made with an automatic coupling. For the squeegee, it is also possible
to tune the angle of the rubber blades with respect to the hard floor surface.
2.
Regulate the pressure of the vacuum head on carpet or hard floor.
3.
Regulate the height from floor of the rotating brush, so that you obtain more or less strength in the
action of the rotating brush on the carpet. To lower the brush you must pull the knob located in the
lower rear part of the machine and turn it counter-clockwise. To lift the brush, you must turn it
clockwise. We recommend you to lift completely the brush after finishing the work and before storing
the machine, in order to avoid its damage.
For carpet cleaning, the position generally used is the second-last one. The last position, instead, is
indicated for cleaning hard floor, which usually requires a stronger action of the brush.
For hard floor cleaning, a specific harder brush is also available.
Verify that the brush inserted in the machine is the appropriate type for the surface to be cleaned. In
particular, the optional specific brush for hard floor should not be used on carpet, since it might be too
aggressive for carpet and damage it, or it could cause an overload of the brush motor.
Attention: The brush motor is protected from overload, by a protection located on the control panel. If
this protection intervenes, it is necessary to reduce the pressure of the brush, to avoid the overload of
the motor. If this is not enough to avoid that the protection repeatedly intervenes, you should contact the
Use as a Self-contained Machine
13
Rudder bar to
lift and lower
the vacuum head
Publicité
