Onkyo CR-N775D Mode D'emploi page 40

> Before Start > Part Names
This can be set only when "Wi-Fi" is selected in "Connection Type".
0 You can make Wi-Fi connection settings using a web browser on a computer. For
details, refer to "Web Setup" (
∫ DHCP
"On" (Default Value): Auto configuration by DHCP
"Off": Manual configuration without DHCP
If selecting "Off", you must set "IP Address", "Subnet Mask", "Gateway", and "DNS
Server" manually.
∫ IP Address
Displays/Sets the IP address.
∫ Subnet Mask
Displays/Sets the subnet mask.
∫ Gateway
Displays/Sets the gateway.
∫ DNS Server
Displays/Sets the primary DNS server.
∫ Proxy URL
Displays/Sets the proxy server URL.
∫ Proxy Port
Displays/Sets the proxy server port number when you enter "Proxy URL".
∫ Friendly Name
Change the device name for this unit which is shown on other devices connected to
the network to an easily recognized name. You can input up to 31 characters. For
details on how to enter text, refer to "Entering text" (
40
> Install
P43).
P36).
> Initial Setup > Playback
∫ AirPlay Password
You can set a password of up to 31 characters so that only registered users can use
AirPlay. For details on how to enter text, refer to "Entering text" (
∫ Network Check
You can check the network connection.
Option
∫ Power Management
Auto Standby
Network Standby
Supplementary information |
This setting places the unit on standby automatically after
20 minutes of inactivity without any audio input.
"On": The unit will automatically enter standby mode.
"Off": The unit will not automatically enter standby mode.
0 Default values vary depending on the regions.
When this feature is turned "On", you can turn on the power
of the unit via the network using an application that can
control this unit.
0 When you have selected "On (USB Power)" and this unit
is on standby, you can use a computer connected to the
same network as this unit to access an HDD connected
to the USB port on the rear of the main unit.
0 If either "On" (default setting) or "On (USB Power)" is
selected, power consumption during standby becomes
larger than normal.
0 When the connection to the network is lost, "Network
Standby" may be disabled to reduce power
consumption.
Advanced Setup | Others
P36).