Onkyo CR-N775D Mode D'emploi page 29

> Before Start > Part Names
When playing a device connected to the DIGITAL IN
COAXIAL terminal, press INPUT 2/1 repeatedly to
change the input on this unit to "COAXIAL".
COAXIAL
44.1kHz
When playing a device connected to the LINE IN
jacks, press INPUT 2/1 repeatedly to change the
input on this unit to "LINE".
LINE
2. Start play on the player.
0 When connected by a digital optical cable or digital
coaxial cable, this unit supports linear PCM signals
of up to 192 kHz/24 bits for input.
Connecting with Onkyo RI Components
By connecting an Onkyo component with RI jack to the
unit by using an RI cable and an analog audio cable,
you can link the unit's power and input selection and
enable operation with this unit's remote controller. For
details, refer to the instruction manual of the
component with the RI jack.
0 When connecting an Onkyo MD deck, you need to
change the name of the input selector. (
> Install
"Input Name")
Change the name of the jack to which the external
device is connected, "COAXIAL", "OPTICAL", etc.,
to "MD".
Asb
Asb
a RI Cable, b Analog Audio Cable
0 If there are two RI connectors, the function of the two
connectors is the same. Both connectors can be
used.
0 Connection to RI connectors only does not work as
the system. Connect also an analog audio cable
correctly.
0 Some components may not support all RI functions.
P42,
> Initial Setup > Playback
a
b
Supplementary information | Advanced Setup | Others
29
En