LaserLiner PowerCheck Mode D'emploi page 8

2
To set battery type
The switch (4) must be set to the corresponding position depending
on the type of battery.
a b c
e
3
To check battery charge
!
Refer to Point 2
„To set battery type".
Open the battery holder and insert
battery corresponding to the +/-
symbols or place block batteries
on the contacts 3a and 3b. Be
sure to pay attention to polarity.
3-colour display scale
Good (green): battery
fully charged
Weak (orange): battery is
weak and will soon need
replacing
Replace (red): battery is flat
and should be replaced
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies) before
storing for longer periods. Store the device in a clean and dry place.
08
EN
d
a 1.5V round cells (AA, AAA, C, D)
b 1.2V round cells (NiMH)
(AA, AAA, C, D)
c 8.4V flat cells (NiMH) (E-block)
d 9.0V flat cells (E-block)
e 1.5V button cell (small)
f f
3.0V button cell (small / large)